§ 63.167. Standards: Open-ended valves or lines.
256 words·~1 min read·
/us/cfr/t40/s§ 63.167·A research copy — for the controlling text, always check the official state or federal source. Not legal advice.
(a)(1) Each open-ended valve or line shall be equipped with a cap, blind flange, plug, or a second valve, except as provided in § 63.162(b) of this subpart and paragraphs
(d)and
(e)of this section.
(2)The cap, blind flange, plug, or second valve shall seal the open end at all times except during operations requiring process fluid flow through the open-ended valve or line, or during maintenance or repair.
(b)Each open-ended valve or line equipped with a second valve shall be operated in a manner such that the valve on the process fluid end is closed before the second valve is closed.
(c)When a double block and bleed system is being used, the bleed valve or line may remain open during operations that require venting the line between the block valves but shall comply with paragraph
(a)of this section at all other times.
(d)Open-ended valves or lines in an emergency shutdown system which are designed to open automatically in the event of a process upset are exempt from the requirements of paragraphs (a),
(b)and
(c)of this section.
(e)Open-ended valves or lines containing materials which would autocatalytically polymerize or, would present an explosion, serious overpressure, or other safety hazard if capped or equipped with a double block and bleed system as specified in paragraphs
(a)through
(c)of this section are exempt from the requirements of paragraph
(a)through
(c)of this section. [59 FR 19568, Apr. 22, 1994, as amended at 61 FR 31440, June 20, 1996]
Connections13 cite this
Cited by 13 sections · top 4
Citation graph
cites case law
§ 63.167
Standards: Open-ended valves or lines.
Fed. Reg.×13
Cites 0Cited by 13 across 1 source