§ 63.1543. Standards for process and process fugitive sources.
571 words·~3 min read·
/us/cfr/t40/s§ 63.1543·A research copy — for the controlling text, always check the official state or federal source. Not legal advice.
(a)No owner or operator of any existing, new, or reconstructed primary lead processor shall discharge or cause to be discharged into the atmosphere lead compounds in excess of 0.97 pounds per ton of lead metal produced from the aggregation of emissions discharged from air pollution control devices used to control emissions from the sources listed in paragraphs (a)(1) through
(9)of this section.
(1)Sinter machine;
(2)Blast furnace;
(3)Dross furnace;
(4)Dross furnace charging location;
(5)Blast furnace and dross furnace tapping location;
(6)Sinter machine charging location;
(7)Sinter machine discharge end;
(8)Sinter crushing and sizing equipment; and
(9)Sinter machine area.
(b)No owner or operator of any existing, new, or reconstructed primary lead processor shall discharge or cause to be discharged into the atmosphere lead compounds in excess of 1.2 tons per year from the aggregation of the air pollution control devices used to control emissions from furnace area and refining and casting operations.
(c)The process fugitive sources listed in paragraphs (a)(4) through
(8)of this section must be equipped with a hood and must be ventilated to a baghouse or equivalent control device. The hood design and ventilation rate must be consistent with American Conference of Governmental Industrial Hygienists recommended practices.
(d)The sinter machine area must be enclosed in a building that is ventilated to a baghouse or equivalent control device at a rate that maintains a positive in-draft through any doorway opening.
(e)Except as provided in paragraph
(f)of this section, following the initial tests to demonstrate compliance with paragraphs
(a)and
(b)of this section, the owner or operator of a primary lead processor must conduct compliance tests for lead compounds on a quarterly basis (no later than 100 days following any previous compliance test).
(f)If the 12 most recent compliance tests demonstrate compliance with the emission limit specified in paragraphs
(a)and
(b)of this section, the owner or operator of a primary lead processor shall be allowed up to 12 calendar months from the last compliance test to conduct the next compliance test for lead compounds.
(g)The owner or operator of a primary lead processor must maintain and operate each baghouse used to control emissions from the sources listed in paragraphs (a)(1) through
(9)and
(b)of this section such that the alarm on a bag leak detection system required under § 63.1547(c)(8) does not sound for more than five percent of the total operating time in a 6-month reporting period.
(h)The owner or operator of a primary lead processor must record the date and time of a bag leak detection system alarm and initiate procedures to determine the cause of the alarm according to the corrective action plan required under § 63.1547(f) within 1 hour of the alarm. The cause of the alarm must be corrected as soon as practicable.
(i)At all times, the owner or operator must operate and maintain any affected source, including associated air pollution control equipment and monitoring equipment, in a manner consistent with safety and good air pollution control practices for minimizing emissions. Determination of whether such operation and maintenance procedures are being used will be based on information available to the Administrator which may include, but is not limited to, monitoring results, review of operation and maintenance procedures, review of operation and maintenance records, and inspection of the source. [76 FR 70853, Nov. 15, 2011]
Connections2 cite this
Cited by 2 sections · top 1
register
Citation graph
cites case law
§ 63.1543
Standards for process and process fugitive sources.
Fed. Reg.×2
Cites 0Cited by 2 across 1 source