§ 62.14670. How do I demonstrate continuous compliance with the emission limitations and the operating limits?
146 words·~1 min read·
/us/cfr/t40/s§ 62.14670·A research copy — for the controlling text, always check the official state or federal source. Not legal advice.
(a)You must conduct an annual performance test for particulate matter, hydrogen chloride, and opacity for each CISWI unit as required under 40 CFR 60.8 to determine compliance with the emission limitations. The annual performance test must be conducted using the test methods listed in table 1 of this subpart and the procedures in § 62.14650.
(b)You must continuously monitor the operating parameters specified in § 62.14635 or established under § 62.14640. Operation above the established maximum or below the established minimum operating limits constitutes a deviation from the established operating limits. Three-hour rolling average values are used to determine compliance (except for baghouse leak detection system alarms) unless a different averaging period is established under § 62.14640. Operating limits do not apply during performance tests.
(c)You must only burn the same types of waste used to establish operating limits during the performance test.
Connections2 cite this · traces to 1
Cited by 2 sections · top 1
register
Traces to 1 document
Citation graph
cites case law
§ 62.14670
How do I demonstrate continuous compliance with the emission limitations and the operating limits?
Fed. Reg.×2
Cites 1Cited by 2 across 1 source