§ 60.4385a. How are SO2 excess emissions and monitor downtime reported?
458 words·~2 min read·
/us/cfr/t40/s§ 60.4385a·A research copy — for the controlling text, always check the official state or federal source. Not legal advice.
(a)If you choose the option to monitor the sulfur content of the fuel, excess emissions and monitor downtime are defined as follows:
(1)For samples obtained using daily sampling, flow proportional sampling, or sampling from the unit's storage tank, excess emissions occur each operating hour included in the period beginning on the date and hour of any sample for which the sulfur content of the fuel being fired in the stationary combustion turbine exceeds the applicable standard and ending on the date and hour that a subsequent sample is taken that demonstrates compliance with the sulfur standard.
(2)If the option to sample each delivery of fuel oil has been selected, you must immediately switch to one of the other oil sampling options (i.e., daily sampling, flow proportional sampling, or sampling from the unit's storage tank) if the sulfur content of a delivery exceeds 0.05 weight percent, 0.15 weight percent, or 0.40 weight percent as applicable. You must continue to use one of the other sampling options until all of the oil from the delivery has been combusted, and you must evaluate excess emissions according to paragraph
(a)of this section. When all of the fuel from the delivery has been combusted, you may resume using the as-delivered sampling option.
(3)A period of monitor downtime begins when a required sample is not taken by its due date. A period of monitor downtime also begins on the date and hour of a required sample, if invalid results are obtained. The period of monitor downtime ends on the date and hour of the next valid sample.
(b)If you choose the option to maintain records of the fuel sulfur content, excess emissions are defined as any period during which you combust a fuel that you do not have appropriate fuel records or that fuel contains sulfur greater than the applicable standard.
(c)For reports required under § 60.4375a(a), periods of excess emissions and monitor downtime for stationary combustion turbines using a CEMS, excess emissions are reported as specified in paragraphs (c)(1) and
(2)of this section.
(1)An excess emission that must be reported is any unit operating period in which the 4-operating-hour or 30-operating-day rolling average SO2 emissions rate exceeds the applicable emissions standard in § 60.4330a as determined in § 60.4374a.
(2)A period of monitor downtime that must be reported is any operating hour in which the data for any of the following parameters that you use to calculate the emission rate, as applicable, used to determine compliance, are either missing or out-of-control: SO2 concentration, CO2 or O2 concentration, stack flow rate, heat input rate, steam flow rate, steam temperature, steam pressure, or megawatts. You are only required to monitor parameters used for compliance purposes.