Tap any paragraph to write a margin note. Your notes collect in the Desk below the text and file under cases with @. The side-by-side margin rail opens on a larger screen.

§
Marginalia
Code · CFR · Title 30 — Mineral Resources · Part 18 · § 18.32

§ 18.32. Fastenings---additional requirements.

317 words·~1 min read·/us/cfr/t30/s§ 18.32·

A research copy — for the controlling text, always check the official state or federal source. Not legal advice.

(a)Bolts, screws, or studs shall be used for fastening adjoining parts to prevent the escape of flame from an enclosure. Hinge pins or clamps will be acceptable for this purpose provided MSHA determines them to be equally effective.
(b)Lockwashers shall be provided for all bolts, screws, and studs that secure parts of explosion-proof enclosures. Special fastenings designed to prevent loosening will be acceptable in lieu of lockwashers, provided MSHA determines them to be equally effective.
(c)Fastenings shall be as uniform in size as practicable to preclude improper assembly.
(d)Holes for fastenings shall not penetrate to the interior of an explosion-proof enclosure, except as provided in paragraph (a)(9) of § 18.34, and shall be threaded to insure that a specified bolt or screw will not bottom even if its lockwasher is omitted.
(e)A minimum of 1/8-inch of stock shall be left at the center of the bottom of each hole drilled for fastenings.
(f)Fastenings used for joints on explosion-proof enclosures shall not be used for attaching nonessential parts or for making electrical connections.
(g)The acceptable sizes for and spacings of fastenings shall be determined by the size of the enclosure, as indicated in § 18.31.
(h)MSHA reserves the right to conduct explosion tests with standard bolts, nuts, cap screws, or studs substituted for any special high-tensile strength fastening(s) specified by the applicant.
(i)Coil-thread inserts, if used in holes for fastenings, shall meet the following:
(1)The inserts shall have internal screw threads.
(2)The holes for the inserts shall be drilled and tapped consistent with the insert manufacturer's specifications.
(3)The inserts shall be installed consistent with the insert manufacturer's specifications.
(4)The insert shall be of sufficient length to ensure the minimum thread engagement of fastening specified in § 18.31(a)(6) of this part. \[33 FR 4660, Mar. 19, 1968, as amended at 57 FR 61210, Dec. 23, 1992\]
★   the supreme law of the land   ★
Don't Tread on Me
E Pluribus Unum — out of many, one

"If you don't know your rights, you don't have any."

Marginalia · a citizen's law index
A research desk, not legal advice. Always read the cited source before relying on a summary.
Questions or an issue? support@self-law.org
disclaimerMarginalia is a research index, not a law firm. Nothing on this site is legal, tax, or financial advice and no attorney–client relationship is formed by using it. Statutes, regulations, and case law change; summaries, search results, AI output, and member posts may be incomplete, out of date, or wrong. Any interpretation drawn from material on this site should be validated by a licensed attorney in your jurisdiction before you act on it.