§ 43.15. Additional performance rules for inspections.
512 words·~2 min read·
/us/cfr/t14/s§ 43.15·A research copy — for the controlling text, always check the official state or federal source. Not legal advice.
(a)General. Each person performing an inspection required by part 91, 125, or 135 of this chapter, shall—
(1)Perform the inspection so as to determine whether the aircraft, or portion(s) thereof under inspection, meets all applicable airworthiness requirements; and
(2)If the inspection is one provided for in part 125, 135, or § 91.409(e) of this chapter, perform the inspection in accordance with the instructions and procedures set forth in the inspection program for the aircraft being inspected.
(b)Rotorcraft. Each person performing an inspection required by Part 91 on a rotorcraft shall inspect the following systems in accordance with the maintenance manual or Instructions for Continued Airworthiness of the manufacturer concerned:
(1)The drive shafts or similar systems.
(2)The main rotor transmission gear box for obvious defects.
(3)The main rotor and center section (or the equivalent area).
(4)The auxiliary rotor on helicopters.
(c)Annual and 100-hour inspections.
(1)Each person performing an annual or 100-hour inspection shall use a checklist while performing the inspection. The checklist may be of the person's own design, one provided by the manufacturer of the equipment being inspected or one obtained from another source. This checklist must include the scope and detail of the items contained in appendix D to this part and paragraph
(b)of this section.
(2)Each person approving a reciprocating-engine-powered aircraft for return to service after an annual or 100-hour inspection shall, before that approval, run the aircraft engine or engines to determine satisfactory performance in accordance with the manufacturer's recommendations of—
(i)Power output (static and idle r.p.m.);
(ii)Magnetos;
(iii)Fuel and oil pressure; and
(iv)Cylinder and oil temperature.
(3)Each person approving a turbine-engine-powered aircraft for return to service after an annual, 100-hour, or progressive inspection shall, before that approval, run the aircraft engine or engines to determine satisfactory performance in accordance with the manufacturer's recommendations.
(d)Progressive inspection.
(1)Each person performing a progressive inspection shall, at the start of a progressive inspection system, inspect the aircraft completely. After this initial inspection, routine and detailed inspections must be conducted as prescribed in the progressive inspection schedule. Routine inspections consist of visual examination or check of the appliances, the aircraft, and its components and systems, insofar as practicable without disassembly. Detailed inspections consist of a thorough examination of the appliances, the aircraft, and its components and systems, with such disassembly as is necessary. For the purposes of this subparagraph, the overhaul of a component or system is considered to be a detailed inspection.
(2)If the aircraft is away from the station where inspections are normally conducted, an appropriately rated mechanic, a certificated repair station, or the manufacturer of the aircraft may perform inspections in accordance with the procedures and using the forms of the person who would otherwise perform the inspection. [Doc. No. 1993, 29 FR 5451, Apr. 23, 1964, as amended by Amdt. 43-23, 47 FR 41086, Sept. 16, 1982; Amdt. 43-25, 51 FR 40702, Nov. 7, 1986; Amdt. 43-31, 54 FR 34330, Aug. 18, 1989; 71 FR 44188, Aug. 4, 2006]
Connections5 cite this
Citation graph
cites case law
§ 43.15
Additional performance rules for inspections.
Fed. Reg.×5
Cites 0Cited by 5 across 1 source