§ 35.35. Centrifugal load tests.
257 words·~1 min read·
/us/cfr/t14/s§ 35.35·A research copy — for the controlling text, always check the official state or federal source. Not legal advice.
The applicant must demonstrate that a propeller complies with paragraphs (a),
(b)and
(c)of this section without evidence of failure, malfunction, or permanent deformation that would result in a major or hazardous propeller effect. When the propeller could be sensitive to environmental degradation in service, this must be considered. This section does not apply to fixed-pitch wood or fixed-pitch metal propellers of conventional design.
(a)The hub, blade retention system, and counterweights must be tested for a period of one hour to a load equivalent to twice the maximum centrifugal load to which the propeller would be subjected during operation at the maximum rated rotational speed.
(b)Blade features associated with transitions to the retention system (for example, a composite blade bonded to a metallic retention) must be tested either during the test of paragraph
(a)of this section or in a separate component test for a period of one hour to a load equivalent to twice the maximum centrifugal load to which the propeller would be subjected during operation at the maximum rated rotational speed.
(c)Components used with or attached to the propeller (for example, spinners, de-icing equipment, and blade erosion shields) must be subjected to a load equivalent to 159 percent of the maximum centrifugal load to which the component would be subjected during operation at the maximum rated rotational speed. This must be performed by either:
(1)Testing at the required load for a period of 30 minutes; or
(2)Analysis based on test. [Amdt. 35-8, 73 FR 63348, Oct. 24, 2008]