§ 25.933. Reversing systems.

341 words·~2 min read·/us/cfr/t14/s§ 25.933·

A research copy — for the controlling text, always check the official state or federal source. Not legal advice.

(a)For turbojet reversing systems—

(1)For each system intended for ground operation only, the applicant must show—

(i)The airplane is capable of continued safe flight and landing during and after any thrust reversal in flight; or

(ii)The system complies with § 25.1309(b) using the assumption the airplane would not be capable of continued safe flight and landing during and after an in-flight thrust reversal.

(2)Each system intended for inflight use must be designed so that no unsafe condition will result during normal operation of the system, or from any failure (or reasonably likely combination of failures) of the reversing system, under any anticipated condition of operation of the airplane including ground operation. Failure of structural elements need not be considered if the probability of this kind of failure is extremely remote.

(3)Each system must have means to prevent the engine from producing more than idle thrust when the reversing system malfunctions, except that it may produce any greater forward thrust that is shown to allow directional control to be maintained, with aerodynamic means alone, under the most critical reversing condition expected in operation.

(b)For propeller reversing systems—

(1)Each system intended for ground operation only must be designed so that no single failure (or reasonably likely combination of failures) or malfunction of the system will result in unwanted reverse thrust under any expected operating condition. Failure of structural elements need not be considered if this kind of failure is extremely remote.

(2)Compliance with this section may be shown by failure analysis or testing, or both, for propeller systems that allow propeller blades to move from the flight low-pitch position to a position that is substantially less than that at the normal flight low-pitch position. The analysis may include or be supported by the analysis made to show compliance with the requirements of § 35.21 of this chapter for the propeller and associated installation components. [Amdt. 25-72, 55 FR 29784, July 20, 1990, as amended by Doc. No. FAA-2022-1544, 89 FR 68734, Aug. 27, 2024]