§ 25.723. Shock absorption tests.
213 words·~1 min read·
/us/cfr/t14/s§ 25.723·A research copy — for the controlling text, always check the official state or federal source. Not legal advice.
(a)The analytical representation of the landing gear dynamic characteristics that is used in determining the landing loads must be validated by energy absorption tests. A range of tests must be conducted to ensure that the analytical representation is valid for the design conditions specified in § 25.473.
(1)The configurations subjected to energy absorption tests at limit design conditions must include at least the design landing weight or the design takeoff weight, whichever produces the greater value of landing impact energy.
(2)The test attitude of the landing gear unit and the application of appropriate drag loads during the test must simulate the airplane landing conditions in a manner consistent with the development of rational or conservative limit loads.
(b)The landing gear may not fail in a test, demonstrating its reserve energy absorption capacity, simulating a descent velocity of 12 f.p.s. at design landing weight, assuming airplane lift not greater than airplane weight acting during the landing impact.
(c)In lieu of the tests prescribed in this section, changes in previously approved design weights and minor changes in design may be substantiated by analyses based on previous tests conducted on the same basic landing gear system that has similar energy absorption characteristics. [Doc. No. 1999-5835, 66 FR 27394, May 16, 2001]
Connections2 cite this
Citation graph
cites case law
§ 25.723
Shock absorption tests.
Fed. Reg.×2
Cites 0Cited by 2 across 1 source