§ 25.613. Material strength properties and material design values.
269 words·~1 min read·
/us/cfr/t14/s§ 25.613·A research copy — for the controlling text, always check the official state or federal source. Not legal advice.
(a)Material strength properties must be based on enough tests of material meeting approved specifications to establish design values on a statistical basis.
(b)Material design values must be chosen to minimize the probability of structural failures due to material variability. Except as provided in paragraphs
(e)and
(f)of this section, compliance must be shown by selecting material design values which assure material strength with the following probability:
(1)Where applied loads are eventually distributed through a single member within an assembly, the failure of which would result in loss of structural integrity of the component, 99 percent probability with 95 percent confidence.
(2)For redundant structure, in which the failure of individual elements would result in applied loads being safely distributed to other load carrying members, 90 percent probability with 95 percent confidence.
(c)The effects of environmental conditions, such as temperature and moisture, on material design values used in an essential component or structure must be considered where these effects are significant within the airplane operating envelope.
(d)[Reserved]
(e)Greater material design values may be used if a “premium selection” of the material is made in which a specimen of each individual item is tested before use to determine that the actual strength properties of that particular item will equal or exceed those used in design.
(f)Other material design values may be used if approved by the Administrator. [Doc. No. 5066, 29 FR 18291, Dec. 24, 1964, as amended by Amdt. 25-46, 43 FR 50595, Oct. 30, 1978; Amdt. 25-72, 55 FR 29776, July 20, 1990; Amdt. 25-112, 68 FR 46431, Aug. 5, 2003]