§ 25.519. Jacking and tie-down provisions.
271 words·~1 min read·
/us/cfr/t14/s§ 25.519·A research copy — for the controlling text, always check the official state or federal source. Not legal advice.
(a)General. The airplane must be designed to withstand the limit load conditions resulting from the static ground load conditions of paragraph
(b)of this section and, if applicable, paragraph
(c)of this section at the most critical combinations of airplane weight and center of gravity. The maximum allowable load at each jack pad must be specified.
(b)Jacking. The airplane must have provisions for jacking and must withstand the following limit loads when the airplane is supported on jacks—
(1)For jacking by the landing gear at the maximum ramp weight of the airplane, the airplane structure must be designed for a vertical load of 1.33 times the vertical static reaction at each jacking point acting singly and in combination with a horizontal load of 0.33 times the vertical static reaction applied in any direction.
(2)For jacking by other airplane structure at maximum approved jacking weight:
(i)The airplane structure must be designed for a vertical load of 1.33 times the vertical reaction at each jacking point acting singly and in combination with a horizontal load of 0.33 times the vertical static reaction applied in any direction.
(ii)The jacking pads and local structure must be designed for a vertical load of 2.0 times the vertical static reaction at each jacking point, acting singly and in combination with a horizontal load of 0.33 times the vertical static reaction applied in any direction.
(c)Tie-down. If tie-down points are provided, the main tie-down points and local structure must withstand the limit loads resulting from a 65-knot horizontal wind from any direction. [Doc. No. 26129, 59 FR 22102, Apr. 28, 1994]
Connections4 cite this
Cited by 4 sections · top 2
Citation graph
cites case law
§ 25.519
Jacking and tie-down provisions.
Fed. Reg.×4
Cites 0Cited by 4 across 1 source