§ 25.367. Unsymmetrical loads due to engine failure.
239 words·~1 min read·
/us/cfr/t14/s§ 25.367·A research copy — for the controlling text, always check the official state or federal source. Not legal advice.
(a)The airplane must be designed for the unsymmetrical loads resulting from the failure of the critical engine. Turbopropeller airplanes must be designed for the following conditions in combination with a single malfunction of the propeller drag limiting system, considering the probable pilot corrective action on the flight controls:
(1)At speeds between VMC and VD, the loads resulting from power failure because of fuel flow interruption are considered to be limit loads.
(2)At speeds between VMC and VC, the loads resulting from the disconnection of the engine compressor from the turbine or from loss of the turbine blades are considered to be ultimate loads.
(3)The time history of the thrust decay and drag build-up occurring as a result of the prescribed engine failures must be substantiated by test or other data applicable to the particular engine-propeller combination.
(4)The timing and magnitude of the probable pilot corrective action must be conservatively estimated, considering the characteristics of the particular engine-propeller-airplane combination.
(b)Pilot corrective action may be assumed to be initiated at the time maximum yawing velocity is reached, but not earlier than two seconds after the engine failure. The magnitude of the corrective action may be based on the control forces specified in § 25.397(b) except that lower forces may be assumed where it is shown by anaylsis or test that these forces can control the yaw and roll resulting from the prescribed engine failure conditions.
Connections2 cite this
Cited by 2 sections
Citation graph
cites case law
§ 25.367
Unsymmetrical loads due to engine failure.
Fed. Reg.×2
Cites 0Cited by 2 across 1 source