§ 21.101. Designation of applicable regulations.

873 words·~4 min read·/us/cfr/t14/s§ 21.101·

A research copy — for the controlling text, always check the official state or federal source. Not legal advice.

(a)An applicant for a change to a type certificate must show that the change and areas affected by the change comply with the airworthiness requirements applicable to the category of the product in effect on the date of the application for the change and with parts 34, 36, and 38 of this chapter. Exceptions are detailed in paragraphs

(b)and

(c)of this section.

(b)Except as provided in paragraph

(g)of this section, if paragraphs (b)(1), (2), or

(3)of this section apply, an applicant may show that the change and areas affected by the change comply with an earlier amendment of a regulation required by paragraph

(a)of this section, and of any other regulation the FAA finds is directly related. However, the earlier amended regulation may not precede either the corresponding regulation included by reference in the type certificate, or any regulation in §§ 25.2, 27.2, or 29.2 of this chapter that is related to the change. The applicant may show compliance with an earlier amendment of a regulation for any of the following:

(1)A change that the FAA finds not to be significant. In determining whether a specific change is significant, the FAA considers the change in context with all previous relevant design changes and all related revisions to the applicable regulations incorporated in the type certificate for the product. Changes that meet one of the following criteria are automatically considered significant:

(i)The general configuration or the principles of construction are not retained.

(ii)The assumptions used for certification of the product to be changed do not remain valid.

(2)Each area, system, component, equipment, or appliance that the FAA finds is not affected by the change.

(3)Each area, system, component, equipment, or appliance that is affected by the change, for which the FAA finds that compliance with a regulation described in paragraph

(a)of this section would not contribute materially to the level of safety of the product or would be impractical.

(c)An applicant for a change to an aircraft (other than a rotorcraft) of 6,000 pounds or less maximum weight, to a non-turbine rotorcraft of 3,000 pounds or less maximum weight, to a level 1 low-speed airplane, or to a level 2 low-speed airplane may show that the change and areas affected by the change comply with the regulations included in the type certificate. However, if the FAA finds that the change is significant in an area, the FAA may designate compliance with an amendment to the regulation incorporated by reference in the type certificate that applies to the change and any regulation that the FAA finds is directly related, unless the FAA also finds that compliance with that amendment or regulation would not contribute materially to the level of safety of the product or would be impractical.

(d)If the FAA finds that the regulations in effect on the date of the application for the change do not provide adequate standards with respect to the proposed change because of a novel or unusual design feature, the applicant must also comply with special conditions, and amendments to those special conditions, prescribed under the provisions of § 21.16, to provide a level of safety equal to that established by the regulations in effect on the date of the application for the change.

(e)An application for a change to a type certificate for a transport category aircraft is effective for 5 years, and an application for a change to any other type certificate is effective for 3 years. If the change has not been approved, or if it is clear that it will not be approved under the time limit established under this paragraph, the applicant may do either of the following:

(1)File a new application for a change to the type certificate and comply with all the provisions of paragraph

(a)of this section applicable to an original application for a change.

(2)File for an extension of the original application and comply with the provisions of paragraph

(a)of this section. The applicant must then select a new application date. The new application date may not precede the date the change is approved by more than the time period established under this paragraph (e).

(f)For aircraft certificated under §§ 21.17(b), 21.24, 21.25, and 21.27 the airworthiness requirements applicable to the category of the product in effect on the date of the application for the change include each airworthiness requirement that the FAA finds to be appropriate for the type certification of the aircraft in accordance with those sections.

(g)Notwithstanding paragraph

(b)of this section, for transport category airplanes, the applicant must show compliance with each applicable provision of part 26 of this chapter, unless the applicant has elected or was required to comply with a corresponding amendment to part 25 of this chapter that was issued on or after the date of the applicable part 26 provision. [Doc. No. 28903, 65 FR 36266, June 7, 2000, as amended by Amdt. 21-90, 72 FR 63404, Nov. 8, 2007; Amdt. 21-96, 77 FR 71695, Dec. 4, 2012; Doc. No. FAA-2015-1621, Amdt. 21-100, 81 FR 96689, Dec. 30, 2016; Doc. No. FAA-2022-0241, Amdt. No. 21-107, 89 FR 12653, Feb. 16, 2024]

Connections442 cite this

Cited by 442 sections · top 60

Citation graph

cites case law

§ 21.101

Designation of applicable regulations.

Fed. Reg.×442

Cites 0Cited by 442 across 1 source