§ 171.209. Installation requirements.
237 words·~1 min read·
/us/cfr/t14/s§ 171.209·A research copy — for the controlling text, always check the official state or federal source. Not legal advice.
(a)The facility must be installed according to accepted good engineering practices, applicable electric and safety codes, and Federal Communications Commission requirements.
(b)The facility must have a reliable source of suitable primary power.
(c)Dual transmitting equipment may be required, if applicable, to support certain IFR procedures.
(d)At facilities within or immediately adjacent to controlled airspace and that are intended for use as instrument approach aids for an airport, there must be ground-air communications or reliable communications (at least a landline telephone) from the airport to the nearest Federal Aviation Administration air traffic control or communication facility. Compliance with this paragraph need not be shown at airports where an adjacent Federal Aviation Administration facility can communicate with aircraft on the ground at the airport and during the entire proposed instrument approach procedure. In addition, at low traffic density airports within or immediately adjacent to controlled airspace, and where extensive delays are not a factor, the requirements of this paragraph may be reduced to reliable communications (at least a landline telephone) from the airport to the nearest Federal Aviation Administration air traffic control or communications facility, if an adjacent Federal Aviation Administration facility can communicate with aircraft during the proposed instrument approach procedure, at least down to the minimum en route altitude for the controlled airspace area. [Docket 10116, 35 FR 12716, Aug. 11, 1970, as amended by Amdt. 171-16, 56 FR 65665, Dec. 17, 1991]