Notices. ENVIRONMENTAL PROTECTION AGENCY

187 words·~1 min read·/register/2015/04/21/2015-09202

A research copy — for the controlling text, always check the official state or federal source. Not legal advice.

BILLING CODE 6560-50-P ENVIRONMENTAL PROTECTION AGENCY 40 CFR Part 63 National Emission Standards for Hazardous Air Pollutants for Source Categories CFR Correction In Title 40 of the Code of Federal Regulations, Part 63, §§ 63.1 to 63.599, revised as of July 1, 2014, on page 478, in § 63.343, paragraph (c)(5)(ii) is correctly revised to read as follows: § 63.343 Compliance provisions. [Corrected]

(c)* * *

(5)* * *

(ii)On and after the date on which the initial performance test is required to be completed under § 63.7, the owner or operator of an affected source shall monitor the surface tension of the electroplating or anodizing bath. Operation of the affected source at a surface tension greater than the value established during the performance test, or greater than 40 dynes/cm, as measured by a stalagmometer, or 33 dynes/cm, as measured by a tensiometer, if the owner or operator is using this value in accordance with paragraph (c)(5)(i) of this section, shall constitute noncompliance with the standards. The surface tension shall be monitored according to the following schedule: [FR Doc. 2015-09202 Filed 4-20-15; 8:45 am]

Connections1 off-index

1 reference not yet in our index

40 CFR 63

Citation graph

cites case law

Notices

ENVIRONMENTAL PROTECTION AGENCY

Cite40 CFR 63

Cites 1Cited by 0 across 0 sources