Proposed Rules. Notice of proposed rulemaking (NPRM)

Agency: Federal Aviation Administration, DOT
Action: Notice of proposed rulemaking (NPRM)
Citation: FR Doc. 00-32574 · RIN 2120-AA64 · Docket No. 2000-NM-222-AD · 14 CFR 39

Summary

This document proposes the adoption of a new airworthiness directive (AD) that is applicable to certain Saab Model SAAB SF340A and SAAB 340B series airplanes. This proposal would require installation of a new circuit breaker and related wiring, and relocation of circuit breaker 12FG, if applicable. This action is necessary to prevent loss of the nose wheel steering and reduced controllability of the airplane on the ground. This action is intended to address the identified unsafe condition.

Dates

Comments must be received by Janury 22, 2001.

Supplementary Information

Comments Invited Interested persons are invited to participate in the making of the proposed rule by submitting such written data, views, or arguments as they may desire. Communications shall identify the Rules Docket number and be submitted in triplicate to the address specified above. All communications received on or before the closing date for comments, specified above, will be considered before taking action on the proposed rule. The proposals contained in this action may be changed in light of the comments received. Submit comments using the following format: • Organize comments issue-by-issue. For example, discuss a request to change the compliance time and a request to change the service bulletin reference as two separate issues. • For each issue, state what specific change to the proposed AD is being requested. • Include justification (e.g., reasons or data) for each request. Comments are specifically invited on the overall regulatory, economic, environmental, and energy aspects of the proposed rule. All comments submitted will be available, both before and after the closing date for comments, in the Rules Docket for examination by interested persons. A report summarizing each FAA-public contact concerned with the substance of this proposal will be filed in the Rules Docket. Commenters wishing the FAA to acknowledge receipt of their comments submitted in response to this action must submit a self-addressed, stamped postcard on which the following statement is made: “Comments to Docket Number 2000-NM-222-AD.” The postcard will be date stamped and returned to the commenter. Availability of NPRMs Any person may obtain a copy of this NPRM by submitting a request to the FAA, Transport Airplane Directorate, ANM-114, Attention: Rules Docket No. 2000-NM-222-AD, 1601 Lind Avenue, SW., Renton, Washington 98055-4056. Discussion The Luftfartsverket (LFV), which is the airworthiness authority for Sweden, notified the FAA that an unsafe condition may exist on certain Saab Model SAAB SF340A and SAAB 340B series airplanes. The LFV advises that it has received reports in which an emergency extension of the landing gear was necessary due to a popped or non-resettable circuit breaker, which resulted in loss of the nose wheel steering and reduced controllability of the airplane on the ground. This circuit is also common for the locked-down signals of the weight-on-wheel and landing gear to other systems (i.e., nose wheel steering and flight idle stop). The circuit breaker failure has been attributed to the lack of another circuit breaker that would supply 28 volts direct current (VDC) to the relays. This condition, if not corrected, could result in loss of the nose wheel steering and reduced controllability of the airplane on the ground. Explanation of Relevant Service Information Saab has issued Service Bulletin 340-32-120, Revision 01, dated August 29, 2000, which describes procedures for installation of a new circuit breaker and related wiring. Accomplishment of the actions specified in the service bulletin is intended to adequately address the identified unsafe condition. The LFV classified this service bulletin as mandatory and issued Dutch airworthiness directive (SAD) 1-155, dated February 28, 2000, in order to assure the continued airworthiness of these airplanes in Sweden. FAA's Conclusions These airplane models are manufactured in Sweden and are type certificated for operation in the United States under the provisions of § 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and the applicable bilateral airworthiness agreement. Pursuant to this bilateral airworthiness agreement, the LFV has kept the FAA informed of the situation described above. The FAA has examined the findings of the LFV, reviewed all available information, and determined that AD action is necessary for products of this type design that are certificated for operation in the United States. Explanation of Requirements of Proposed Rule Since an unsafe condition has been identified that is likely to exist or develop on other airplanes of the same type design registered in the United States, the proposed AD would require accomplishment of the actions specified in the service bulletin described previously. Cost Impact The FAA estimates that 312 Saab Model SAAB SF340A and SAAB 340B series airplanes of U.S. registry would be affected by this proposed AD. It would take approximately 7 work hours per airplane to accomplish the proposed installation, at an average labor rate of $60 per work hour. Required parts would cost approximately $177 per airplane. Based on these figures, the cost impact of the proposed AD on U.S. operators is estimated to be $186,264, or $597 per airplane. The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the proposed requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions. Regulatory Impact The regulations proposed herein would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this proposal would not have federalism implications under Executive Order 13132. For the reasons discussed above, I certify that this proposed regulation (1) is not a “significant regulatory action” under Executive Order 12866; (2) is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) if promulgated, will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A copy of the draft regulatory evaluation prepared for this action is contained in the Rules Docket. A copy of it may be obtained by contacting the Rules Docket at the location provided under the caption ADDRESSES. List of Subjects in 14 CFR Part 39 Air transportation, Aircraft, Aviation safety, Safety. The Proposed Amendment Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration proposes to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows: PART 39—AIRWORTHINESS DIRECTIVES 1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. § 39.13 [Amended] 2. Section 39.13 is amended by adding the following new airworthiness directive: Saab Aircraft AB: Docket 2000-NM-222-AD. Applicability: The following airplanes, certificated in any category: Model Serial numbers SAAB SF340A -004 through -159 inclusive SAAB 340B -160 through -459 inclusive, except -342, -379, -395, -409, -431, and -455 Note 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it. Compliance: Required as indicated, unless accomplished previously. To prevent loss of the nose wheel steering and reduced controllability of the airplane on the ground, accomplish the following: Installation of Circuit Breaker and Related Wiring and Relocation of the Circuit Breaker, if Applicable (a) Within 6 months after the effective date of this AD, install a new circuit breaker and related wiring, per Saab Service Bulletin 340-32-120, Revision 01, dated August 29, 2000. Alternative Methods of Compliance (b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, International Branch, ANM-116, FAA. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, International Branch, ANM-116. Note 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the International Branch,ANM-116. Special Flight Permits (c) Special flight permits may be issued in accordance with §§ 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished. Note 3: The subject of this AD is addressed in Dutch airworthiness directive (SAD) 1-155, dated February 28, 2000. Issued in Renton, Washington, on December 15, 2000. Dorenda D. Baker, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. 00-32574 Filed 12-20-00; 8:45 am]