Sec. 301. Effluent limitations for wastewater, spills, and runoff from plastic polymer production facilities, plastic molding and forming facilities, and other point sources associated with the transport and packaging of plastic pellets or other preproduction plastic materials
278 words·~1 min read·
/bill/118/hr/6053/ih/section-301·A research copy — for the controlling text, always check the official state or federal source. Not legal advice.
Not later than 60 days after the date of enactment of this Act, the Administrator of the Environmental Protection Agency (referred to in this section as the Administrator ) shall promulgate a final rule to ensure that— the discharge of plastic pellets or other preproduction plastic materials (including discharge into wastewater and other runoff) from facilities regulated under part 414 or 463 of title 40, Code of Federal Regulations (as in effect on the date of enactment of this Act), is prohibited; the discharge of plastic pellets or other preproduction plastic materials (including discharge into wastewater and other runoff) from a point source (as defined in section 502 of the Federal Water Pollution Control Act ( 33 U.S.C. 1362 )) that makes, uses, packages, or transports those plastic pellets and other preproduction plastic materials is prohibited; and the requirements under paragraphs
(1)and
(2)are reflected in— all wastewater, stormwater, and other permits issued by the Administrator and State-delegated programs under section 402 of the Federal Water Pollution Control Act ( 33 U.S.C. 1342 ) to facilities and other point sources (as defined in section 502 of that Act ( 33 U.S.C. 1362 )) that make, use, package, or transport plastic pellets or other preproduction plastic materials, as determined by the Administrator, in addition to other applicable limits and standards; and all standards of performance promulgated under section 312(p) of the Federal Water Pollution Control Act ( 33 U.S.C. 1322(p) ) that are applicable to point sources (as defined in section 502 of that Act ( 33 U.S.C. 1362 )) that make, use, package, or transport plastic pellets or other preproduction plastic materials, as determined by the Administrator.
Connectionstraces to 3
Citation graph
cites case law
Sec. 301
Effluent limitations for wastewater, spills, and runoff from plastic polymer production facilities, plastic molding and forming facilities, and other point sources associated with the transport and packaging of plastic pellets or other preproduction plastic materials
Cites 3Cited by 0 across 0 sources